![]() ![]() it might fail here if you use a flash drive, because flash drives are not working with cIOS, but should work with WD HDDs. The IOS switch will be done only if needed = at wii game launch using the "game's IOS" setting usually set to 249. it will automatically edit the meta.xml to reflect the IOS you chose so both the meta.xml (use to boot the loader) and the loader's IOS (used inside the loader) are identical to prevent the need to switch the IOS and re-initialize the USB. Usually, you don't edit the meta.xml or config file manually, but change the loader's IOS from the internal loader's interface. Using IOS58 is a solution to initialize the HDD.īut you should keep IOS58 for "laoder's IOS" setting too, so it doesn't reinitialize, it keeps IOS58 once into the loader. I'm ready to do some experimenting if you have any ideas. I hope with all my heart for help to get this resolved. If I do a cold boot and start USB Loader GX without doing anything (either from HBC or from a forwarder) it freezes at reinitializing devices. I can see all GC and WII applicaitons and start them. Now it get past the initialize usb device, but freezes at reinitializing devices.īut if I run SysCheck first I can right after start USB Loader GX and it works without freezing. Well I also tried a 2TB WD Green something in an external hard drive cabinet and that worked only if I connected it when the loader starts waiting for USB HDD. VIOS251 (rev 21010, Info: d2x-v10beta52-vWii): NAND Access, USB 2.0Īt some point I had it to work if I didn't connect the USB HDD (WD My Book Essentials 2TB MBR, FAT32) untill it waits 20 sec for USB HDD. SysCheck HDE v2.4.0 HacksDen Edition by JoostinOnline, Double_A, R2-D2199, and Nanoįound 34 IOS on this console. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |