You can use sandpaper and alcohol to do this. Make your copper clad board as clean as possible beforehand. Put the board in FeCl3 solution for a while Why “modified”? Because toner transfer method requires a temperature of 210☌, where a laminator can provide 150☌ maximum. You can use a modified laminator machine or an iron for this purpose. All you need to do is place the printed side of the glossy paper on the copper board and apply both pressure and heat. In this step, the PCB design from glossy paper will be transferred to the copper board. Cut the copper clad board using a hacksaw Toner Transfer and Etching Process: Also, cut the printed glossy paper as per the size of PCB. If it’s smaller than the actual PCB then you have to do it again. Now, cut the copper clad board according to the dimensions of the PCB.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |